Pt3000_p2, Assembly instruction, Pt3000 – ikan PT3000 User Manual

Page 3

ASSEMBLY INSTRUCTION

Attach the 100mm Mounting Bracket (Part K) to the back

of the 15” monitor using 4 x Short Phillip’s head screws

(Part H). The two flaps of Part K should be perpendicular

to the monitor control buttons.

Attach 4 x T-slot Nuts (Part D) and 4 x Long Phillips Head

Screws (Part G) as shown on the diagram.

Attach the 20” T-slot with Metal Bracket (Part P) to the

assembled parts. You will use 2 x T-plates (Part C) and

4 x Long Phillips Head screws (Part G) to do so. Make

sure to evenly tighten all screws in this assembly.

Remove protective film from Part-L.

> Unscrew the 4 small screws

that are pre-placed in Part L.

> Remove glass holding tabs on

both sides.

> Peel the protective film away.

> Re-install the teleprompter glass back

into the metal frame.

Part-L

PT3000

15” TELEPROMPTER

Part-I

Part-M

Part-P

Attach Short L-Bracket (Part I) to 8” T-slot (Part M)

using 2 x T-plates (Part C) and 4 x Long Phillips head

screws (Part G). Refer to illustration below for configu-

ration. The Short L-Bracket’s (Part I) top half should be

flush with the edge of the 8” T-slot (Part M).

Part-G

Part-C

PT3000

Rear view of 15” monitor

Part-K

Part-D

Part-G

Part-H

2 of 10

This manual is related to the following products: