IHSE USA R434-91 Series SDLink Rackmount Hubs - Manual (Page 17)

Installation 15
Remote Unit Installation
To install a Remote Unit:
1. Switch off all devices.
2. Connect your keyboard, monitor(s) and mouse to the Remote Unit as shown
in Figure 2 (single and dual head units) or Figure 4 (quad head units).
These ports may also be attached to the CPU side of a KVM switch in order
to have a remote CPU. However, if you are attempting to use the extender
between cascaded KVM switches this may not work. Please contact Technical
Support to discuss your application.
3. If appropriate, connect audio equipment and serial devices. Connect the
audio cables as follows:
Remote Unit Audio Device
Audio Out Speakers
Audio In (MIC) Microphone
See Appendix E: Audio/Serial Ports: Operation & Multi-Port
Configuration, page 54 for further information.
4. Connect the Primary CATx cable to the INTERCONNECT (1) socket on
the front of the Remote Unit. For Dual and Quad systems, connect
additional CATx cables as required (see Figure 3 and Figure 5).
5. Connect the 9V power supply to power the unit.
Only use the power supply originally supplied with this
equipment or a manufacturer approved replacement.
NEVER CONNECT THE REMOTE UNIT 9V POWER SUPPLY TO A
LOCAL UNIT: YOU WILL DAMAGE THE EXTENDER SYSTEM.
Choose a well-ventilated location for a quad head unit. When in
use, these can generate a considerable amount of heat.