IHSE USA 434 Series SD- VUE/5x - Manual (Page 19)

Installation 17
Figure 4 Local Unit - rear view
Status Yellow LED* Green LED
OFF
ON No data transfer between
Local and Remote Units: not
connected, or Remote Unit
not powered.
Powered Remote Unit
found. Local Unit not powered, or in an
over-voltage (>6.0V) or under-
voltage (<4.3V) condition.
Local Unit powered correctly.
* Yellow LED active on primary INTERCONNECT socket (Channel 1) only
Figure 5 Local Unit – front view
Connect to
primary Local
monitor.
Connect to audio
ports on
computer. Connect to
serial port on
computer.
SD-VUE/50A and SD-VUE/52A only
Connect to
computer’s primary
video output. Connect to USB
port on CPU (or
external hub).
INTERCONNECT 1 – carries primary
video and USB signals. Connect to
CATx cable from INTERCONNECT 1
port on Remote Unit. INTERCONNECT 2 – carries secondary
video and audio/serial data (SD-VUE/52A
only). Connect to CATx cable from
INTERCONNECT 2 port on Remote Unit.
SD-VUE/52 and SD-VUE/52A only All Models
Connect to
secondary Local
monitor. Connect to computer’s
secondary video
output.
SD-VUE/52 and SD-VUE/52A only
All Local Units
Connect to 5V
PSU (optional).