IHSE USA 434 Series SD- VUE/5x - Manual (Page 16)

14 SD-VUE USB Mini Extender Range
Connecting the Remote Unit
To install a Remote Unit:
1. Connect your monitor, USB and other devices to the Remote Unit as shown
in Figure 2 (single and dual-head units).
If additional USB hubs are attached to the extender, the maximum
extension distance could be reduced (due to the delay imposed by each
hub). For each connected hub, you may lose up to 10m of extension
distance. Note: any USB device to which additional USB peripherals may
be attached is a USB hub (e.g. an Apple® USB keyboard).
2. If appropriate, connect audio equipment and serial devices. Connect the
audio cables as follows:
Remote Unit Audio Device
Audio Out Speakers
Audio In (MIC) Microphone
See Appendix C: Audio/Serial Ports, page 29 for further information.
3. Connect the Primary CATx cable to the INTERCONNECT (1) socket on
the front of the Remote Unit. For dual head systems and SD-VUE/50A
(uses a second CATx cable to extend audio and serial data only), connect an
additional CATx cable to INTERCONNECT (2) (see Figure 3).
4. Connect the 5V power supply to power the unit.
Only use the power supply originally supplied with this
equipment or a manufacturer approved replacement.
5. If you are using a flat panel TFT monitor, you must adjust the clock
and/or phase, either manually or by using auto-adjust. Refer to the manual
supplied with your monitor.