Hypertherm HD4070 Rev.8 - Manual (Page 122)

OPERATION
0
4-12 HD4070 Instruction Manual
AUTO
MAN
THC JOG
DOWN JOG
UP
TORCH 1
READY
STAINLESS STEEL
NEW
PROCESS
NEXT
AUTO
MAN
THC ARC
VOLT ARC
VOLT
OVERRIDE VOLTS: 144.5 V
SET ARC VOLTS: 142.0 V
INLET GAS: H35 N2
TRAVEL SPEED: 65 IPM
3/4 IN
200 AMPS STANDOFF: 0.050 IN
++
_ _
13
TORCH 1
READY
STAINLESS STEEL
AUTO
MAN
THC ARC
VOLT ARC
VOLT
OVERRIDE VOLTS: 144.5 V
SET ARC VOLTS: 142.0 V
INLET GAS: H35 N2
TRAVEL SPEED: 65 IPM
3/4 IN
200 AMPS STANDOFF: 0.050 IN
++
_ _
13
NEW
PROCESS
NEXT
AUTO
MAN
THC STEP
DOWN STEP
UP
System Operation Screens – continued 4
Use the ARC VOLT buttons to adjust the arc volts.
Adjust arc volts
Adjust torch height
The lifter can be manually moved up or down in two
ways. For large adjustments, press the AUTO MAN
THC button and then use the JOG UP and JOG DOWN
buttons. The lifter will continue to move as long as the
button is pressed. For small adjustments, press the
AUTO MAN THC button again and use the STEP UP
and STEP DOWN buttons. Each time you press the UP
or DOWN button the lifter will move .003 inches
(.08mm).
IMPORTANT: When the JOG UP and JOG DOWN or
the STEP UP and STEP DOWN buttons are displayed,
the Arc Volt Torch Height Control function is disabled. To
restore Arc Volt Torch Height Control, press the AUTO
MAN THC button until you return to the original screen.
Return to first screen