Hypertherm HD4070 Rev.8 - Manual (Page 121)

OPERATION
0
HD4070 Instruction Manual 4-11
TORCH 1
PURGING
STAINLESS STEEL
AUTO
MAN
THC ARC
VOLT ARC
VOLT
OVERRIDE VOLTS: 144.5 V
SET ARC VOLTS: 142.0 V
INLET GAS: H35 N2
TRAVEL SPEED: 65 IPM
3/4 IN
200 AMPS STANDOFF: 0.050 IN
++
_ _
13
CNC
TORCH 1
NO PILOT ARC
STAINLESS STEEL
AUTO
MAN
THC ARC
VOLT ARC
VOLT
OVERRIDE VOLTS: 144.5 V
SET ARC VOLTS: 142.0 V
INLET GAS: H35 N2
TRAVEL SPEED: 65 IPM
3/4 IN
200 AMPS STANDOFF: 0.050 IN
++
_ _
13
CNC
TORCH 1
READY
STAINLESS STEEL
AUTO
MAN
THC ARC
VOLT ARC
VOLT
OVERRIDE VOLTS: 144.5 V
SET ARC VOLTS: 142.0 V
INLET GAS: H35 N2
TRAVEL SPEED: 65 IPM
3/4 IN
200 AMPS STANDOFF: 0.050 IN
++
_ _
13
NEXT
NEW
PROCESS
NEXT
NEW
PROCESS
NEXT
NEW
PROCESS
System Operation Screens 4
When screen 13 first appears, the system will
purge all gas lines.
After the gases are purged, the screen will display
READY indicating that the power supply is ready to
receive the start signal from the CNC.
Screen 13 provides process information so that the
operator can view what parameters are being used.
Error codes are displayed at the top of the screen.
The system will clear some error codes and will then
return to the READY state.
When an error occurs
that freezes the system software, a RESET button
appears in place of NEW PROCESS. Pushing
RESET clears the error without having to turn the
power off.
See Maintenance Section 5 for a complete list of
error codes and corrective actions.
Display will advance to screen 14.