Hypertherm SuperMicro 370SBA 533Mhz - Manual (Page 70)

SUPER 370SBA/370SBM/370SLA/370SLM User’s Manual
5-18
H/W Monitor In0 (CPU 1)
H/W Monitor In1 (CPU 2 - grayed out for Celeron processor)
H/W Monitor In2 (+3.3V)
H/W Monitor In3 (+5V)
H/W Monitor In4 (+12V)
H/W Monitor In5 (-12V)
H/W Monitor In6 (-5V)
CPU1 Fan
CPU2 Fan (grayed out for Celeron processor)
Thermal Control Fan (grayed out for Celeron processor)
The above features are for PC Health Monitoring. The motherboards with
W83781D have seven on-board voltage monitors for the CPU core, CPU
I/O, +3.3V, +5V, -5V, +12V, and -12V, and three fan status monitors.
Power Loss Control
This option determines how power is restored in the event of AC power
loss. Settings are: Always OFF , Always ON , or Previous . Always OFF
provides no automatic power loss control, and power is controlled by the
chassis POWER switch. Always ON will automatically power-on the system
whenever source power is applied to the system (the power cord is plugged
in). The Previous setting remembers the previous power state (ON or
OFF), and restores that power state upon the return of source power.
Keyboard Wake-up Function
This option allows the system to ‘wake-up’ from standby or sleep mode by
pressing any key on the keyboard. Settings are Disabled or Enabled .
Note: The JPWAKE jumper on the system board must be set to 2-3
before the Enabled setting will work.
On-Board FDC
This option enables the FDC (Floppy Drive Controller) on the motherboard.
The settings are Auto (AMIBIOS automatically determines if the floppy
controller should be enabled), Disabled , or Enabled .
On-Board Serial Port A
This option specifies the base I/O port address of serial port 1. The
settings are Auto (AMIBIOS automatically determines the correct base I/O
port address), Disabled , 3F8h/ COM1, 2F8h/COM2 , 3E8h/COM3 or 2E8h/
COM4 .