Hypertherm SuperMicro 370SBA 533Mhz User Manual
Page 47
3-5
Chapter 3: Troubleshooting
"Y" to start the BIOS flash procedure and do not disturb your system until the
flash utility displays that the procedure is complete. After updating your BIOS,
clear CMOS then load Optimal Values in the BIOS.
Question:
After flashing the BIOS my system does not have video. How
can I correct this?
Answer:
If the system does not have video after flashing your new BIOS, it
indicates that the flashing procedure failed. To remedy this, first clear CMOS per
the instructions in this manual and retry the BIOS flashing procedure. If you still
do not have video, please use the following BIOS recovery procedure. Turn your
system off and place the floppy disk with the saved BIOS image file (see above
FAQ) in drive A. Press and hold
turn on the power with these keys pressed until your floppy drive starts reading.
Your screen will remain blank until the BIOS program is done. If the system
reboots correctly, then the recovery was successful.
Question:
I have memory problems. What is the correct memory to use
and which BIOS setting should I choose?
Answer:
The correct memory to use on the SUPER 370SBA/370SBM/370SLA/
370SLM is 168-pin DIMM 3.3v non-buffered SPD (Serial Present Detection)
SDRAM, SDRAM and EDO memory. SPD SDRAM is preferred but is not essen-
tial. IMPORTANT: Please do not mix memory types; the results are unpredict-
able. If your memory count is exactly half of the correct value, please go to the
BIOS in Chipset Setup and set "SDRAM AUTOSIZING SUPPORT" to
Enabled
.
Change between available options until one setting correctly displays your
memory.
Question:
Which Operating System (OS) supports AGP?
Answer:
At present, Windows 98 and Windows NT 5.0 are the only OS that have
built-in support for AGP. Some AGP video adapters can run Windows 95 OSR2.1
with special drivers. Please contact your graphics adapter vendor for more
details.
Question:
Do I need the CD that came with your motherboard?
Answer:
The supplied compact disc has quite a few drivers and programs that
will greatly enhance your system. We recommend that you review the CD and
install the applications you need. Applications included on the CD are PCI IDE
Bus Master drivers for Windows 95 and Windows NT, 440BX/LX chip set drivers
for Windows 95 and Super Doctor Monitoring software.