Hypertherm SuperMicro 370SBA 533Mhz - Manual (Page 66)

SUPER 370SBA/370SBM/370SLA/370SLM User’s Manual
5-14
Device 6 (Serial port 1)
Device 7 (Serial port 2)
Device 8 (Parallel port)
Device 5 (Floppy disk)
Device 0 (Primary Master IDE)
Device 1 (Primary Slave IDE)
Device 2 (Secondary Master IDE)
Device 3 (Secondary Slave IDE)
When set to Monitor , these options enable event monitoring on the speci-
fied hardware interrupt request line. If set to Monitor and the computer is
in a power saving state, AMIBIOS watches for activity on the specifies IRQ
line. The computer enters the Full On state if any activity occurs.
AMIBIOS reloads the Standby and Suspend timeout timers if activity occurs
on the specified IRQ line. Note: The Optimal default setting for each
option is Ignore with the exception of Devices 0 (Primary Master IDE)
and 6 (Serial Port 1) which should be set to Monitor. The Fail-Safe
default for each option is Monitor.
LAN Wake-Up
RTC Wake-Up
Options for LAN Wake-Up and RTC (Real Time Clock) Wake-Up are
Disabled or Enabled . When RTC Wake-Up is enabled, the Hour and
Minute settings can be set to the desired wake-up time relative to the
current real time clock.
PCI/PnP Setup
Plug and Play-Aware OS
The settings for this option are No or Yes . Set this option to Yes if the
operating system in the computer is aware of and follows the Plug and Play
specification. AMIBIOS only detects and enables PnP ISA adapter cards
that are required for system boot. Currently, only Windows 95 is PnP-
Aware. Set this option to No if the operating system (such as DOS, OS/2,
Windows 3.x) does not use PnP. You must set this option correctly.
Otherwise, PnP-aware adapter cards installed in the computer will not be
configured properly.
PCI Latency Timer (PCI Clocks)
This option specifies the latency timings in PCI clocks for all PCI devices.
The settings are 32 , 64 , 96 , 128 , 160 , 192 , 224 , or 248 .