Highgear Axis User Manual
Page 17
ALTIWARE SERIES
TABLE OF CONTENTS
31
english
axis
TABLE OF CONTENTS
32
english
CLEARING LAPS AND RUNS
To CLEAR an individual RUN/WORKOUT, advance to the desired
Run/Workout using the
S2
key.
PRESS
&
HOLD
the
S4
key. The display
will show the RUN number in the top line of the display, HOLD flashing
in the center line and CLEAR in the lower line. Continue holding the
S4
key until the message in the lower line changes ALL.
RELEASE
the
S4
key before the ALL indication stops flashing, or you will clear ALL the
runs in memory.
To delete ALL RUN/WORKOUT files, continue to
PRESS
&
HOLD
S4
key while the ALL message is displayed in the lower line. When files
are cleared, 4 DASHES will be displayed in the center line.
CHRONOGRAPH DATA LOG MEMORY
DAILY ALARM
TURNING AN ALARM ON/OFF
1. Starting in ALARM mode.
2. The top line of the display will show either AL1 or AL2, the
center line will show the CURRENT ALARM SETTING and
the lower line will indicate if the alarm is ON or OFF.
3.
TOGGLE
between ON and OFF using
QUICK
PRESSES
of
the
S1
key.
SELECTING ALARM 1 OR 2
TOGGLE
between ALARM 1 and ALARM 2 shown in the top line
of the display using the
S2
key.
The Axis is equipped with two individual daily alarms which can be set to the hour and minute for
either Time Zone 1 or Time Zone 2.