Highgear Axis User Manual

Page 18

ALTIWARE SERIES

TABLE OF CONTENTS

english

axis

TABLE OF CONTENTS

english

SETTING THE DAILY ALARM

1. Choose

the

TIME ZONE you wish to program an alarm for in the TIME OF DAY screen.

2. Starting in ALARM mode.
3.

SELECT

the alarm you wish to program using the

key.

PRESS

HOLD

the

key to enter the programming sequence.

ADJUST

the HOURS, MINUTES, TIME ZONE and CHIME using the

and

key.

SET

and

ADVANCE

from variable to variable using the

key.

EXIT

SETTING SEQUENCE using the

key.

NOTE:

The CHIME is a single beep each time a key is pressed and a single beep at the start

of each hour. The KEY PRESS CHIME is useful if you are trying to operate the watch under
circumstances where it is difficult to look at the watch to confirm that an action has taken
place when a key is pressed.

RESETTING THE INSTRUMENT

To RESET the instrument back to its default values

PRESS

the

and

keys down at the

same time. The display will light up showing all segments followed by a sequence of screens showing
various numbers. The display will then automatically change to the TIME OF DAY screen at 12 o’clock
on the first of January.
Resetting the instrument will clear any information stored in the instrument. This should be done only
as a last resort.

DAILY ALARM

SPECIFICATIONS AND RANGES

GENERAL

Operational Temperature -10C to +50C/ 14F to 122F
Water Resistance 3ATM
Watch Battery CR 2032 3v Lithium

ALTIMETER

Range -703 to +9158m / -2305 to +30,045f
Resolution 1m / 1f
20 Memories with Date, Time and Altitude

THERMOMETER

Range -10 to +50C / +14 to +122F
Resolution 0.1C/0.1F

COMPASS

Resolution of 1 degree
Bearing direction in degrees and half-cardinal points

BAROMETER

Range 300 to 1100mbar
Resolution 1mbar

CHRONOGRAPH

Range 24 hours
Resolution 0.01 second for first hour; 1.0 second for hours 2-23

CHRONOGRAPH LOG

100 Laps/Splits
30 Runs/Workouts showing Lap/split times, Best Lap/Split, Average Lap/Splits