Highgear AltiTech 1 - Manual (Page 13)

CHRO DATA – Chronograph Data Mode
Setting Up
No setup is necessary. The AltiTech stores data from any completed run.
Using the Chronograph Data Mode
You can retrieve data for up to 30 runs and 100 laps from the Chronograph Data
Mode. Change to the mode, Display will show CHRO DATA.
1. AltiTech displays the run number and date of run. You can scroll
through the available runs by pressing B2.
2. Select the run you desire by pressing B3.
3. Scroll through the laps by pressing B3 repeatedly. You will see all the
laps followed by the Best lap (BEST) and average lap speed (AVG).
4. To clear an entire run, view any lap in the run (as above) and hold B4
for 2 seconds. Display shows Run number, HOLD CLEAR Release B4
when display changes to CLEAR HOLD ALL.
5. To clear all the runs, follow the instruction in 4 above, but continue to
hold B4 while display changes to CLEAR HOLD ALL. Release when
display changes to DATA ----
Note:
• Display Shows DATA ---- As above when no data is in memory.
• You cannot erase run information while the chronometer is running.
If you are having trouble deleting, make sure that the timer is stopped.
ALRM - Alarm
Setting Up
The AltiTech has two alarms which can be linked to either of the two Times (T1/T2)
the unit keeps track of.
1. To set the alarm, switch to ALRM mode by pressing B1
(ALRM is shown).
2. Choose the alarm you wish to set Alarm 1 (AL-1) or 2 (AL-2)
with the B2 key.
3. Press and hold B4 until display shows HOUR.
4. Set the time for the alarm in the same way you set the time.
Use B2 (-) and B3 (+) to adjust the hour.
Use B1 to change to the next setting. Set hours and minutes.
5. Now set the time this alarm should use(T1/T2).
Since the AltiTech can keep 2 different times, you’ll need to tell it which
one this alarm should be connected to. If you’re confused, see the Time
section above. Use B2 and B3 to select T1 or T2, then press B1
6. Now select Chime On/Off using B2 and B3. If on, the chime will chirp
at every full hour and to confirm keypresses on the unit. The chime
on/off is not related to the Alarm tone. If the alarm is set, it will sound,
no matter whether you select chime on or off.
Using the Alarm
You can view both alarms by pressing B2. They are displayed as AL-1 and AL-2. The
Time they are associated with (T1/T2) is displayed at the upper left.
You can turn the Alarm on or off using the B3 key. The Alarm icon and the word On or
Off on the bottom line show the current status.
Note:
•
Always double check that the Alarm is connected to the Time (T1/T2) that you
intend. Refer to the TIME section if you need additional help.
• Alarm sounds for 20 seconds. Press any button to stop the alarm.
12