Highgear AltiTech 1 - Manual (Page 11)

CHRO - Chronograph
Setting Up
The Chronograph requires no setup.
Using the Chronograph
The Chronograph is a powerful stopwatch designed to time many different kinds of
activities. The chronograph can time a single race, made up of multiple laps and store
all the important information about both (even the date you ran!)
1. Select Chronograph Mode by pressing B1 (Display shows CHRO).
2. Display should show zeros. If not, see 6 and 7 below.
3. Press B3 to start timing.
Display shows Lap time at top, Split (Total) time at middle, and lap
number at bottom.
4. To take a lap, press B3 again. Display will pause for 6 seconds to
show lap and split time (chronograph is still running) then change to
show current lap and split time.
5. To end the race, press B2. You can retrieve lap information in
CHRONOGRAPH DATA MODE described below. You must end the run
by pressing B2 to allow data to save!
6. To move to another race and save the data, hold B2 for 2 seconds.
7. To clear this race, hold B4 for 3 seconds (display shows CLEAR HOLD).
Note:
• If running, the chronograph continues to time even if you change to another mode on
the AltiTech.
• Chronograph has 1/100 second resolution for the 1st hour, and 1 second resolution
up to 24 hours. Chronograph automatically stops at 24 hours thereafter.
• The AltiTech can store data on 100 laps in 30 runs. AltiTech displays FULL if memory
is exceeded but will continue to time the current race even though no data can be
stored.
B3 Start
Lap B2 Stop
Save
10