Dolby Laboratories 585 - Manual (Page 27)

Model 585 Time Scaling Processor Time Scaling
3-5
you release Shift , the transport returns to stop mode at the position in the clip when
you release Shift .
Holding Shift makes it particularly easy to move through the clip rapidly, but it also
allows you to move slowly at a steady pace, without having to manually turn the
knob.
3.1.2 Record
When you enter the Record menu, you see:
■
00:00.00
■
/
z
P1
Enter Setup Setup
Status
In this menu, the Setup button is a Stop/Record toggle. When you start a recording,
the previous recording is erased, and the previous In point and Out point settings are
cleared.
During recording, the top line displays z and the elapsed recording time. When you
stop a recording, the top line displays
■ and the total time of the clip just recorded. If
you reach the maximum recording time, recording stops automatically.
Pressing Esc stops the recording and exits the Record menu. Selecting Bypass
while in record mode stops the recording.
3.1.3 Program Selection
If the program configuration includes more than one program, use the Program
Select menu to select the appropriate program to record. For a complete list of
program configurations and the associated program numbers and channel
assignments, see Table 7-1.
The second line in the Record menu displays which program records. In the
example shown in Section 3.1.2, Record, P1 indicates that Program 1 will record.
If the current program configuration includes more than one program, you can record
any one of the programs or all the programs. For example, the
5.1 + 2
configuration contains two programs; you can record P1 (program 1), P2 (program
2), or All (both programs). In program configurations with more than two programs,
you can select any single program, or All . Selecting All in any configuration means