Gullco GK-203-400-12 - Manual (Page 5)

3
ELECTRICAL CONNECTION
WARNING! Before connecting the E.A.H.S. to a power source (receptacle, outlet, etc.,) be sure
that the voltage supplied is the same as that specified on the product label. If in
doubt, DO NOT PLUG IN THE E.A.H.S. Copies of the possible product labels are
shown below:
As the colours of the wires in the mains lead of this equipment may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:

The Green & Yellow or Green wire must be connected to the terminal in the plug which is
allocated for “Earth” / “Ground”.

The Blue or White wire must be connected to the terminal that is allocated for “Neutral”.

The Brown or Black wire must be connected to the terminal that is allocated for “Live”.
230V Equipment must be installed in accordance with CEC, NEC or other applicable electrical
code.
WARNING! Ensure proper AC earth grounding of the Gullco E.A.H.S. and all auxiliary equipment
(where applicable), before applying power. Failure to do so may invalidate the
Gullco Warranty.
Note: If other torch mounting hardware is used that was not supplied by Gullco to mount the torch
to the slide, it is important that the torch is electrical isolated from the slide. i.e. no welding current
from the torch must be allowed to pass through the slide. Failure to do so will result in damage to
the E.A.H.S. controls. It is recommended that you consult your local Gullco representative when
considering other torch mounting hardware.
Warranty will be void if genuine Gullco replacement parts are not used.