Gullco GK-203-400-12 - Manual (Page 13)

11
Setting the Dip Switches for control calibration
Located on the back of keypad control board (inside the remote pendant control) there are three (3)
blocks of dip switches “DS71, DS72, and DS73”. All switches come from the factory in the up
position and under normal circumstances will not need adjustment, see below.
WARNING! Always turn the main power off before making any changes to the dip switch positions
on the remote pendant control. Failure to comply may result in control damage.
DS71 is used to calibrate the slide speed or slide tracking speed. It is the speed at which the slide
moves as it compensates for changes in torch height while in Auto mode. It is factory set at 10 IPM
[25.4 cm/min]. It can be increased or decreased in 1 IPM [2.54 cm/min] increments between 3 IPM
[7.62 cm/min] to 17 IPM [43.18 cm/min]. The factory default of 10 IPM [25.4 cm/min] is
recommended for most applications. Where the carriage speed is high and large undulations in the
work piece exist then increasing the slide speed may yield better results. The following table shows
how set the switches for different speeds. Switches 1 to 4 factory set in the up (OFF) position.
Slide speed IPM [cm/min] SWITCH 1 SWITCH 2 SWITCH 3 SWITCH 4
3 [7.62] down down down down
4 [10.16] up down down down
5 [12.5] down up down down
6 [15.24] up up down down
7 [17.78] down down up down
8 [20.32] up down up down
9 [22.86] down up up down
10 [25.4] factory set up up up up
11 [27.94] down up up up
12 [30.48] up down up up
13 [33.02] down down up up
14 [35.56] up up down up
15 [38.1] down up down up
16 [40.64] up down down up
17 [43.18] down down down up