Rack view, Figure 12, T610 mounted in c1 sliding rails – Dell PowerEdge T610 User Manual
Page 48: 4 rack view
Dell
PowerEdge T610 Technical Guide
48
Fully reversible (can be mounted on either side) with no conversion required
Hook-and-loop straps are used rather than plastic tie wraps to eliminate the risk of cable
damage during cycling
A low profile fixed tray to both support and retain the CMA in its fully closed position
Both the CMA and the tray mount without the use of tools using simple and intuitive snap-in
designs
14.4 Rack View
The T610 ReadyRails sliding rails are a drop-in design, meaning that the system is installed vertically
into the rails by inserting the shoulder nuts on the sides of the system into the J-slots in the inner
rail members with the rails in the fully extended position.
Figure 12. T610 Mounted in C1 Sliding Rails
The T610 CMA can be mounted to either side of the rails without the use of tools or the need for
conversion, but it is recommended that it be mounted on the side opposite the power supplies to
allow easier access to the power supplies for service or replacement. Figure 13 shows a T610 system
with a CMA installed.