Dell PowerEdge T610 - Manual (Page 47)

Dell
PowerEdge T610 Technical Guide 47
door panel and the front face of the EIA flange for the front door to close with the 11G server bezel
installed.
Figure 11. 2U Threaded Rack Adapter Brackets Kit
Below is a summary of the rack types supported by the T610 rails. Note that mounting in 2-post racks
is not supported.
Table 15. Supported Racks
Product
Rail
ID
Mounting Interface
Rail
Type
Rack Types Supported
4-Post 2-Post
Square Round Thread Flush Center
T610 C1 ReadyRails Sliding √ √ √ * X X
*Requires the 2U Threaded Rack Adapter Brackets Kit (Dell part number PKCR1)
Other factors to consider when deploying the T610 include the spacing between the front and rear
mounting flanges of the rack, the type and location of any equipment mounted in the back of the
rack such as power distribution units (PDUs), and the overall depth of the rack.
Table 16. Rail Adjustability Ranges and Depth
Product
Rail
ID Mounting
Interface Rail
Type
Rail Adjustability Range (mm) Rail Depth (mm)
Square Round Threaded
Without
CMA With
CMA
Min Max Min Max Min Max
T610 C1 ReadyRails Sliding 692 756 678 749 657 770 760 840
The adjustment range of the rails is a function of the type of rack in which they are being mounted.
The min-max values listed above represent the allowable distance between the front and back
mounting flanges in the rack. Rail depth represents the minimum depth of the rail as measured from
the rack front mounting flanges when the back rail bracket is positioned all the way forward.
14.3 Cable Management Arm (CMA)
The optional cable management arm (CMA) for the T610 organizes and secures the cords and cables
exiting the back of the server and unfolds to allow the server to extend out of the rack without
having to detach the cables.
Some key features of the T610 CMA include:

Large U-shaped baskets to support dense cable loads

Open vent pattern for optimal airflow