Disable sip notify authentication, Cpe ssl certificate, Connection request port – Grandstream HT502 User Manual User Manual
Page 38: Sip tls certificate, Sip tls private key, Sip tls private, Key password
FIRMWARE VERSION 1.0.14.1 HT502 USER MANUAL Page 36 of 54
Automatic Upgrade
Choose “Yes” to enable automatic upgrade and provisioning. If select “Check every
minutes
” input the amount of minutes you want it to check for update. If select “Yes, daily
at hour
” make sure to input the hour of the day you want it to check for update, e.g. for 11
pm type 23. If select “Yes, weekly on day” make sure you input the day of the week (in
format 0-6, 0 is Sunday) you want it to check for update. When set to No, HT502 will only
do the following option you select;
“Always check for New Firmware at Boot up” will check
for new firmware every time the device reboots.
“Check New Firmware only when F/W
pre/suffix changes” will check for updates only when the pre/suffix has been changed.
Disable SIP NOTIFY
Authentication
Device will not challenge NOTIFY with 401 when set to Yes.
Authenticate Conf File If set to Yes, config file is authenticated before acceptance. This protects the
configuration from an unauthorized change.
Firmware Key
Used for firmware encryption. Should be 32 digit in hexadecimal representation. End
user should keep it blank.
SIP TLS Certificate
The user specify SSL certificate used for SIP over TLS in X.509 format.
SIP TLS Private Key
The user specify SSL private key used for SIP over TLS in X.509 format.
SIP TLS Private Key
Password
User specify password to protect the private key above.
ACS URL
User specify the Auto Configuration Server’s URL (TR-069 protocol)
ACS Username
User specify the ACS Username
ACS Password
User specify the ACS password
Periodic Inform
Enable
Default is No. If set to YES, device will send inform packets to the ACS
Periodic Inform
Interval
Frequency that the inform packets will be sent out to the ACS
Connection Request
Username
Set a user name for the ACS to connect to this device
Connection Request
Password
Set a password for the ACS to connect to this device
Connection Request
Port
Set a port number for the ACS to connect to this device, default is 7547
CPE SSL Certificate
Configure the SSL authentication of Customer-premises equipment