Grandstream HT502 User Manual - Manual (Page 27)

FIRMWARE VERSION 1.0.14.1 HT502 USER MANUAL Page 25 of 54
CONFIGURATION GUIDE
CONFIGURING THE HT502 THROUGH VOICE PROMPTS
DHCP M ODE
Select voice menu option 01 to enable HT502 to use DHCP.
STATIC IP M ODE
Select voice menu option 01 to enable HT502 to use STATIC IP mode, then use option 02, 03, 04, 05 to
set up IP address, Subnet Mask, Gateway and DNS server respectively.
F IRMWARE S ERVER IP A DDRESS
Select voice menu option 13 to configure the IP address of the firmware server.
C ONFIGURATION S ERVER IP A DDRESS
Select voice menu option 14 to configure the IP address of the configuration server.
U PGRADE P ROTOCOL
Select voice menu option 15 to choose firmware and configuration upgrade protocol. User can choose
between TFTP and HTTP.
F IRMWARE U PGRADE M ODE
Select voice menu option 17 to choose firmware upgrade mode among the following three options:
1) always check, 2) check when pre/suffix changes, and 3) never upgrade
WAN P ORT W EB A CCESS
Select voice menu option 12 to enable WAN Port Wed Access of the device configuration pages.