Grandstream UCM6100 series Initial Setup Guide - Manual (Page 20)

20
Figure 25: Routes – Create Outbound Route
I NBOUND R OUTES
In the UCM6100, an incoming calling rule allows for various inbound destinations. Users can route
inbound calls by DID, to Extension, Voicemail, Conference Room, Queue, Ring Group, Page, Voicemail
Group, FAX, DISA or IVR. These inbound routes can also be triggered based on a time condition as well.
Inbound routes can be configured via Web GUI->PBX->Basic/Call Routes->Inbound Routes.
• Click on "Create New Inbound Rule" to add a new inbound route.
• Click on "DID Features" to configure DID features for the inbound route.
• Click on "Blacklist" to configure blacklist for all inbound routes.
• Click on
to edit the inbound route.
• Click on
to delete the inbound route.
This section of the tutorial will provide instructions on how to setup an inbound route for a Registered SIP
Trunk. Inbound calls into this SIP trunk will have a default destination as well as a time conditioned
destination.