Delta 31-735 - Manual (Page 11)

11
INSTALLING THE BELT ON THE MOTOR
1. Remove the two screws (A) Fig. 15 from the top of the sanding unit and remove the plate (B).
2. Check to see that the belt (C) Fig. 16 is in the groove of the pulley (D) of the sanding unit.
3. Lift the motor (F) Fig. 17 and place the belt (C) on the motor pulley (G).
4. Slowly lower the motor (F) Fig. 17 to apply pressure to the belt (C).
5. Secure the motor with the hex nuts (H) Fig. 18.
Disconnect the machine from the power source!
Fig. 15 Fig. 16
Fig. 17
Fig. 18
A
B
D
C
C
F
G
H
INSTALLING THE DUST CHUTE
1. Insert the dust chute (A) Fig. 19 through the inside
hole of the cabinet back panel (B) that was removed
earler.
2. Align the four holes in the dust chute (A) Fig. 19 with
the four holes in the back panel (B). Insert an M4-
0.7 x 12mm sheet metal screw through the back
panel (B). Thread the screw into the dust chute.
Tighten securely.
3. Repeat for the three remaining holes.
Disconnect the machine from the power source!
Fig. 19
A
B