GAMMA 6004 STRINGING MACHINE 2 POINT SC MOUNTING (Issue 5C - February 2014) - Manual (Page 6)

6
ASSEMBLY INSTRUCTIONS
Bellows Installation
The bellows assembly is supplied in two
pieces and should be assembled as follows.
Place the bellows section with the fl ange over
the upper support column with the fl ange on
the top. Place the remaining bellows over
the upper support column and mate it with
the fl ange on the lower bellows.
Tool Tray Installation
Lower the tool tray over the top of the upper
column support and let it rest loosely on the
bellows assembly.
Tension Track Installation
Place the tube of the tension track assembly
over the top of the upper column support
and align the tension track with the long
leg of the base. Securely tighten the two
socket set screws on the tension track as-
sembly tube, locking it to the upper column
support. Align the notch in the tool tray with
the tension track bar while raising the tool
tray. Secure the tray with the set screws in
the side of the tray casting.