GAMMA 6004 STRINGING MACHINE 2 POINT SC MOUNTING (Issue 5C - February 2014) - Manual (Page 14)

14
B
A
MAINTENANCE & ADJUSTMENTS
If the lever releases before 60 lbs., using
the supplied L-shaped hex wrench, turn
the adjustment screw (B) located on the
left side of the latch block counter-clockwise
to increase the engagement of the brake
release latch with the brake lever. Repeat
step 1 and adjust until the correct tension
is indicated on the calibrator.
If the tension indicated in step 1 is greater
than 60 lbs., turn the adjustment screw
clockwise to reduce the engagement of the
brake release latch with the brake lever.
Repeat step 1 and adjust until the correct
tension is indicated on the calibrator.
Loosen the 1.5 mm locking set screw (A)
located on the side of the latching block as
shown. The set screw is used to hold the
adjustment screw in place.
Tension Calibration Procedure
Set the tension to 60 lbs. as indicated by
the linear scale and rotary knob. Place the
string on one end of a tension calibrator
into a string clamp and secure. Place string
located on the other end of the calibrator
into the string tensioner and apply tension.
If the brake lever releases before or after 60
lbs., the tension head should be calibrated
as follows.