Accessories – Desa SVYD18NRA/PRA SERIES User Manual

Page 27

www.desatech.com

113084-01A

ACCESSORIES

Purchase these heater accessories from your local
dealer. If they can not supply these accessories,
call DESA Heating Products at 1-866-672-6040
for referral information. You can also write to the
address listed on the back page of this manual.

EQUIPMENT SHUTOFF VALVE
GA5010

For all models. Equipment shutoff valve with 1/8"
NPT tap. Fits 1/2" NPT pipe.

RECEIVER AND HAND-HELD
THERMOSTAT REMOTE CONTROL
KIT - GHRCTB

For remote-ready models. Allows the gas log
heater to be operated in a manually or thermostati-
cally controlled mode. You can turn the gas log
heater on and off without ever leaving the com-
fort of your easy chair.

RECEIVER AND HAND-HELD
REMOTE CONTROL KIT - GHRCB

For remote-ready models. Allows the gas log
heater to be turned on and off by using a hand-
held remote control.

WALL-MOUNT THERMOSTAT
SWITCH GWMT1

(Not Shown)

For remote-ready models. The desired comfort
setting can be selected on the wall thermostat and
the log heater will automatically cycle from pilot
to the heat setting selected.

WALL-MOUNT ON/OFF SWITCH -
GWMS2

(Not Shown)

For remote-ready models. Allows the gas log
heater to be turned on and off with a wall switch.

CLEANING KIT - GCK

(Not Shown)

For all models. Your vent-free gas appliance re-
quires regular cleaning and maintenance to pre-
vent performance problems. This kit gives you the
tools and instructions to make it easy to clean all
critical areas of your appliance.

INFORMATION VIDEO - 108917-01

For all models. A care and maintenance video is
available by calling 1-866-672-6040. You may also
email your request to

[email protected]

FIRE CRACKLE - CF6-A

(Not Shown)

For all models. Creates the sound of a real burn-
ing fire.

STOVE HEARTH BASE - GC10SP

(Not Shown)

For all models. Hearth base stained oak finish.
Required when stove is placed on carpet. Dimen-
sions 4" x 35

/4" x 30

/2" (H x W x D).

STOVE CONVERSION KIT - 113051-01

For models using SVYD18NR/PR vent-free
stove inserts. This kit supplies stove back panel,
stove dropped bottom and needed hardware to
mount the vent-free heater into the stove.