Bios security features – Foxconn D42S User Manual

Page 42

bIoS Security features

► Change Supervisor Password

This item is used to install or change supervisor password.
After you input Supervisor password, it then will ask you to
input user password optionally.
If you have installed the supervisor password, the following items will appear:

► User Access Level

This item is used to set user access level.
The available settings are:
[No Access]: Prevent user access to the setup utility.
[View Only]: Allow access to the setup utility but the fields can not be changed.
[Limited]: Allow only limited fields to be changed, such as date and time.
[Full Access]: Allow any field to be changed except the supervisor password.

► Change User Password

This item is used to install or change user password.

► Clear User Password

This item will be displayed only when a User Password was set before. It is used to clear the
user password.

► Password Check

�hen it is set to [Setup], a password is required to enter the BIOS setup; select [Always], a
password is required not only to enter BIOS setup, but also on each boot of your PC.

► Boot Sector Virus Protection

This item is used to enable/disable boot sector virus protection.

BIOS Security Features

Supervisor Password : Installed

Help Item

User Password

: Installed

Change Supervisor Password

[Press Enter]

Install or change the

User Access Level

[Full Access]

password.

User Access Level

[Full Access]

password.

Change User Password

[Press Enter]

Clear User Password

[Press Enter]

Password Check

[Setup]

Boot Sector Virus Protection

[Disabled]

↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help

F9:Optimized Defaults

[Press Enter]

Enter New Password :

This manual is related to the following products:

D52S