Dram timing configuration – Foxconn D42S User Manual
Page 33
26
3
Memory Configuration
► DRAM Frequency
This item is used to set DRAM frequency. Setting values are: [Auto], [667 MHz], [800 MHz].
DRAM Timing Configuration
► Configure DRAM Timing by SPD
This item is used to enable/disable provision of DRAM timing by SPD device. The Serial
Presence Detect (SPD) device is a small EEPROM chip, mounted on a DDR2 memory
module. It contains important information about the module's speed, size, addressing mode
and various other parameters, so that the motherboard memory controller (chipset) can better
access the memory device.
Select [Enabled] for SPD enable mode.
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
Memory Configuration
Memory Configuration
Memory Configuration
Help Item
DRAM Frequency
[Auto]
Auto
667 MHz
800 MHz
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Auto]
Options
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
DRAM Timing Configuration
DRAM Timing Configuration
Help Item
DRAM Timing Configuration
Help Item
Configure DRAM Timing by SPD [Enabled]
[Enabled]
Disabled
Enabled
Enabled
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Enabled]
Options