Foxconn D42S - Manual (Page 37)

30
3
SuperIO Configuration
► EUP Function
When enable, the suspend power of the NM10 Express chipset will be cut off in S5 suspend
mode; when disable, the suspend power is always on.
► Serial Port1 Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port 1.
► Serial Port� Address
This item is used to assign the I/O address and interrupt request (IRQ) for the serial port 2.
► Parallel Port Address
This item is used to assign the I/O address for the onboard parallel port.
► Parallel Port Mode
This item is used to set parallel port mode.
► Parallel Port IRQ
This item is used to assign interrupt request (IRQ) for the onboard parallel port.
► OnBorard CIR Port
This item is used to assign the I/O address for onboard infrared chip.
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
SuperIO Configuration
Configure ITE8721 Super IO Chipset Help Item
EUP Function [Enabled]
Serial Port1 Address [3F8/IRQ4]
Serial Port2 Address [2F8/IRQ3] Disabled [2F8/IRQ3] Disabled Disabled
Serial Port2 Mode Serial Port2 Mode [Normal] Enabled
Parallel Port Address [378] Parallel Port Address [378] [378]
Parallel Port Mode [Normal]
Parallel Port IRQ [IRQ7]
OnBoard CIR Port [Disabled]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Enabled] Options