Foxconn 45CSX - Manual (Page 35)

3
28
► Serial Port 1 Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port.
► Serial IRDA Address
This item is used to assign the I/O address and interrupt request (IRQ) for the IRDA port.
► IRDA Port Duplex Mode
This item enables you to determine the infrared function of the onboard infrared chip.
► Parallel Port Address
This item is used to assign the I/O address for the onboard parallel port.
► Parallel Port Mode
This item is used to set parallel port mode.
► Parallel Port IRQ
This item is used to assign interrupt request (IRQ) for the onboard parallel port.
USB Configuration
► Legacy USB Support
This item is used to enable the support for USB devices on legacy OS. If you have a USB
keyboard or mouse, set to auto or enabled.
► USB 1.1 Controller
This item is used to enable or disable the Universal Host Controller Interface for USB.
► USB 2.0 Controller
This item is used to enable or disable the Enhanced Host Controller Interface for USB.
If USB devices are connected to the computer, the following item will appear :
► USB Storage Configuration
After pressing , you can set the reset delay for the USB storage device. There are many
different emulation types of this USB device, such as floppy, hard disk and CDROM can be
selected.
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
USB Configuration
USB Configuration Help Item
Module Version - 2.24.1-13.4 Enables support for
legacy USB. AUTO
USB Devices Enabled : option disables
1 Drive legacy support if
Legacy USB Support [Enabled] no USB devices are
USB 1.1 Controller [Enabled] connected.
USB 2.0 Controller [Enabled]
► USB Storage Configuration [Press Enter]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Enabled]