Foxconn 45CSX - Manual (Page 31)

3
24
Memory Configuration
► DRAM Frequency
This item is used to set DRAM frequency. Setting values are: [Auto], [400 MHz], [533 MHz].
DRAM Timing Configuration
► Configure DRAM Timing by SPD
This item is used to enable/disable provision of DRAM timing by SPD device. The Serial
Presence Detect (SPD) device is a small EEPROM chip, mounted on a DDR2 memory
module. It contains important information about the module's speed, size, addressing mode
and various other parameters, so that the motherboard memory controller (chipset) can better
access the memory device.
Select [Enabled] for SPD enable mode.
Select [Disabled] to set the parameters by yourself.
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
Memory Configuration
Memory Configuration Help Item
DRAM Frequency [Auto]
Auto
400 MHz
533 MHz
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Auto] Options
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
DRAM Timing Configuration
DRAM Timing Configuration Help Item
Configure DRAM Timing by SPD [Enabled]
Disabled
Enabled
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Enabled]
Options