Foxconn M61PMX User Manual

Page 28

► SATA Port 1/SATA Port 2

When SATA Operation Mode is set to [IDE], These item will appear . The relationships
between SATA channels and SATA ports on the motherboard are:
SATA Channel 1 Master is the SATA port 1 of the motherboard.
SATA Channel 2 Master is the SATA port 2.

► Driver A

This option allows you to select the kind of FDD to be installed, including "None". [360K, 5.25

in], [1.2M, 5.25 in], [720K, 3.5 in], [1.44M, 3.5 in] and [2.88 M, 3.5 in].

► Halt On

This category determines whether or not the computer will stop if an error is detected during
powering up.

►Configure SATA as

This item is used to set the operating mode of your SATA ports. The available options are:
[IDe] - This configures the SATA ports to support legacy PATA mode or SATA mode.
[RAID] - When you enable RAID, it means all your SATA drives must also support AHCI.

The Installation procedures for AHCI and RAID drivers are the same, they are :

■ Creating a bootable drive (or RAID array).
■ Creating a non-bootable drive (or RAID array).

In Chapter 5, only RAID is introduced. AHCI installation is almost the same, the only
difference is BIOS SATA Operation Mode is set to [AHCI] instead of [RAID].

► Install Memory

This item shows the information of the system memory, determined by POST(Power On Self
Test) of the BIOS.

► Memory Speed

This item shows the information of the system memory frequency, determined by POST(Power
On Self Test) of the BIOS.

► BIOS ID

This item shows the information of the BIOS ID.

All Errors

Whenever the BIOS detects a nonfatal error, the system will stop

and you will be prompted.

No Errors

The system boot will not stop for any errors that may be

detected.

All, But Keyboard The system boot will not stop for a keyboard error; but it will stop

for all other errors.

All, But Diskette

The system boot will not stop for a diskette error; but it will stop

for all other errors.

All, But Disk/Key The system boot will not stop for a keyboard or disk error, but it

will stop for all other errors.