Standard information – Foxconn M61PMX User Manual
Page 27
3
20
Standard Information
This submenu is used to set up the standard BIOS features, such as the date, time, IDE channel
and so on. Use the arrow up/down keys to select an item, then use the <+> or <-> keys to change
the setting.
► Date -
Day—weekday from Sun. to Sat., automatically displayed by BIOS (Read Only).
Month—month from 1 to 12.
Date—date from 1st to 31st.
Year—year, set up by users.
Use
a value.
► Time -
This item allows you to configure the desired time. Use
select a field. Directly input a value or use
value.
► Primary Master/Slave
These categories identify the hard disks connected to the PATA and SATA ports in the system.
In each channel’s display, you can press [Enter] to go to its submenu. You can further config-
ure specific drive settings. [None] and [Auto] settings allow you to enable or disable this drive.
[None] means no HDD is installed or set, and [Auto] means the system can auto-detect the
hard disk when booting up. In Access Mode setting, selections of [CHS], [LBA], [Lage] and
[Auto] can help you to select hard drive for legacy compatibility.
Award (Phoenix) BIOS is supporting 3 HDD modes : CHS, LBA and Large.
CHS
For HDD <528MB
LBA
For HDD >528MB & Supporting LBA (Logical Block Addressing)
Large
For HDD>528MB but not supporting LBA
Note: Set to [Auto] , the system can detect the hard disk and select the HDD mode
automatically. Suggest you select this option.
Phoenix - AwardBIOS CMOS Setup Utility
Standard CMOS Features
Date (mm:dd:yy)
Wed,
Mar
12 2008
Item Help
Time (hh:mm:ss)
18 : 30 : 59
Menu Level ►
► Primary Master
[ None]
Chage the day,month
► Primary Slave
[None]
year and century
►
SATA Port 1
[ST3160815AS]
► SATA Port 2 [TSSTcorp CDDVDW TS-H]
Driver A
[ 1.4MM,3.5 in]
Halt On
[All , But Keyboard]
Configure SATA as [IDE]
Install Memory
2048MB
Memory Speed 800 MHz
BIOS ID
MCP61M01.02.F1.D.03
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F7: Setup Defaults