Fox intelligent stepping – Foxconn A79A-S User Manual

Page 34

► Smart Power LED

Smart Power LED is a feature built on your motherboard to indicate different states during
Power On System Test (POST). The LED is located at the front panel, and it displays POST
state by different long-short blinking intervals. You can always leave this state enabled.
Please refer to the following table.

► Smart Boot Menu

This item is used to enable or disable the smart boot menu. select [F11] will provide a timer
to let user to control boot device easily.

► Current CPU Speed

This item displays the current CPU speed.

► Current FSB/HTT Speed

This item displays the current Front Side Bus speed.

► Current CPU Multiplier

This item displays the current CPU Ratio.

► Current Memory Speed

This item displays the current memory speed.

Fox Intelligent Stepping

► CPU/HT Reference Clock (MHz)

This option is used to adjust the CPU clock.

► PCIE Reference Clock (MHz)

This option is used to adjust the speed of PCI Express slot. It may enhance the graphics card

speed.

Fox Intelligent Stepping

CPU/HT Reference Clock (MHz) [200]

Help Item

PCIE Reference Clock (MHz)

[100]

SB Reference Clock (MHz)

[100]

Processor Frequency (FID)

[Auto]

Spread Spectrum

[Disabled]

► AM2+ CPU Ratio Adjust

[Press Enter]

CPU-NB HT Link Speed

[Auto]

NCHT Incoming Link Width

[Auto]

NCHT Outgoing Link Width

[Auto]

↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help

F9:Optimized Defaults

200

System Status

Power LED Status

Stop Blinking Condition

Normal

Always On

No Memory

Continue blinking On (1sec.), Off (1sec.)

Reboot & Memory OK

No Display

Continue blinking On (2sec.), Off (2sec.)

Reboot & Display OK

Post Error Message

Quick blinking twice (1/3sec. On, 1/3sec. Off),

one long On (1sec.), continuously.

Enter Setup or Skip

No CPU Fan

Continue blinking On (1/2sec.), Off (1/2sec.)

Reboot & Fan OK