Foxconn A7DA Series - Manual (Page 47)

3
40
USB Configuration
► Legacy USB Support
This item is used to enable the support for USB devices on legacy OS. If you have a USB
keyboard or mouse, set to auto or enabled.
► USB 2.0 Controller Mode
This item is used to set the transmission rate mode of USB 2.0. The available settings are :
[High Speed] in 480Mbps; [Full Speed] in 12Mbps.
If USB devices are connected to the computer, the following item will appear :
► USB Storage Configuration
After pressing , you can set the reset delay for the USB mass storage device. There
are many different emulation types of this USB device, such as floppy, hard disk and CDROM
can be selected.
CMOS Setup Utility - Copyright (C) 1985-2006, American Megatrends, Inc.
USB Configuration
USB Configuration Help Item
Module Version - 2.24.3-13.4 Enables support for
legacy USB.
USB Devices Enabled : Auto option disables
1 Drive legacy support if
no USB devices are
Legacy USB Support [Enabled] connected.
USB 2.0 Controller Mode [High Speed]
► USB Storage Configuration [Press Enter]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Enabled]