Foxconn A7DA Series - Manual (Page 21)

2
14
Connect a 4-pin
power plug
We recommend you using an 8-pin ATX 12V power supply. If
you are using a 4-pin power supply, you need to align the ATX
power connector according to the picture on the right.
CA
UT
IO
N
!
exclusive Graphics power Connector : PWR3
This connector is an auxiliary power for graphics card.
Exclusive power for graphics card is for better graphics
performance and future upgrade usage.
floppy Disk Drive Connector : floPPY
This motherboard includes a standard floppy disk
drive(FDD) connector, supporting 360KB, 720KB,1.2MB,
1.44MB, and 2.88MB FDDs.
1394a Connector : f_1394(only avaliable in
A7DA-S)
The 1394a expansion cable can be connected to either
the front (provided that the front panel of your chassis is
equipped with the appropriate interface) or real panel of
the chassis.
IDe Connector : PIDe
With the provided Ultra DMA IDE ribbon cable, you can
connect to any IDE type of hard disk and CD/DVD ROM/RW
drive. You also can configure as a disk array through the
JMicron RAID controller.
+5V
GND
GND
+12V
1
4
GND
+12V
TPA-
TPB-
GND
TPB+
+12V
GND
TPA+
EMPTY
1 2
10 9
F_1394