Foxconn 761GXK8MB-RS User Manual
Page 27
20
Chapter 2 Installation Instructions
Speaker Connector: SPKEAKER
The speaker connector is used to connect
speaker of the chassis.
SPEAKER
SPK
SPKJ
Emypty
NC
1
Additional COM Connector: COM2
This board provides an additional serial
COM connector for your computer. You
need connect the switching-cable to this
connector first, and then connect the serial
COM device with the port of the switching-
cable.
COM2
DSR#
DCD#
RI#
GND
RTS# TXD
EMPTY
DTR#
CTS#
1
2
9
10
RXD
Through this function, system in suspend or
soft-off mode can be waken up by a ring signal
received from the internal modem. W hen this
function is used, be sure an internal modem
card which supports this function is provided.
Then connect the header to the relevant con-
nector on the modem card, set “WOR(RI#) From
Soft-Off” as “Enabled” in the “Power Manage-
ment Setup” section of the CMOS Setup. Save
and exit, then boot the operating system once to
make sure this function takes effect.
1
GND
Modem wake up
5V_SB_SYS
WOM
Wake Up On Modem Connector: WOM(optional)
The connector connects to the chassis security
switch on the case. The system can detect the
chassis intrusion through the status of this
connector. Please set the reference items in
BIOS and save the setting.
1
INTRUDERJ
GND
INTR
Chassis Intruder Connector : INTR
PDF 文件使用 "pdfFactory" 试用版本创建