Foxconn 761GXK8MB-RS User Manual
Page 26
19
Chapter 2 Installation Instructions
Serial ATA Connectors: Serial ATA -1,
Serial ATA -2, Serial ATA -3(optional),
Serial ATA -4(optional)
The Serial ATA header is used to connect the
Serial ATA device to the motherboard.
These connectors support the thin Serial ATA
cables for primary storage devices. The
current Serial ATA interface allows up to
150MB/s data transfer rate.
SATA_1/SATA_2/
SATA_3/SATA_4
GND
GND
GND
TX+
TX-
RX+
RX-
1
S/PDIF Out Connector: SPDIF_OUT1
(optional)
The S/PDIF out connector is capable of provid-
ing digital audio to external speakers or com-
pressed AC3 data to an external Dolby digital
decoder.
SPDIF_OUT1
5V
GND
Empty
DATA
1
Audio Interface: F_AUDIO1
The audio interface provides two kinds of
audio output choices: the Front Audio, the
Rear Audio. Their priority is sequenced from
high to low (Front Audio to Rear Audio). If head-
phones are plugged into the front panel of
the chassis (using the Front Audio), then the
Line-out (Rear Audio) on the rear panel will
not work. If you do not want to use the Front
Audio, pin 5 and 6, pin 9 and 10 must be
short, and then the signal will be sent to the
rear audio port.
Note:
The empty pin of SPDIF cable should be
aligned to empty pin of SPDIF out connector
F_AUDIO1
MIC_GND
MIC
+5VAC
MIC_PW R
AUT_RET_R
AUD_OUT_R
EMPTY
AUD_OUT_L
AUT_RET_L
1
2
9
10
NC
PDF 文件使用 "pdfFactory" 试用版本创建