Foxconn NF4K8AC-RS - Manual (Page 25)

18
Chapter 2 Installation Instructions
The Serial ATA connectors are used to connect the
Serial ATA devices to the motherboard. These con-
nectors support the thin Serial ATA cables for pri-
mary internal storage devices. The current Serial
ATA interface allows up to 150MB/s data transfer
rate.
S-ATA Connectors: SATA0, SATA1, SATA2, SATA3 (optional)
SATA0/1/2/3
GND
GND
GND
RX+
RX-
TX+
TX-
The audio port includes two parts – the Front
Audio and Rear Audio. Their priority is se-
quenced from high to low (Front Audio to Rear
Audio). If headphones are plugged into the
front panel of the chassis (using the Front
Audio), then the Line-Out (Rear Audio) on the
rear panel will not work. If you do not want to
use the Front Audio, pin 5 and 6, pin 9 and 10
must be short, and then the signal will be
sent to the rear audio port.
Front Audio Connector: F_AUDIO1
CD_IN, AUX_IN are Sony standard CD audio
connectors. These connectors allow you to receive
stereo audio input from sound sources such as CD-
ROM. Attach its audio connector to the CD_IN/AUX_IN
audio connectors on the motherboard.
CD_IN1
CD_L
GND
CD_R
AUX_IN1
AUX_R
GND
AUX_L
Speaker Connector: SPK1 (optional)
The speaker connector is used to connect
speaker of the chassis.
F_AUDIO1
MIC_GND MIC_IN
+5VAC MIC_PWR
AUD_RET_R AUD_OUT_R
EMPTY
AUD_OUT_L AUD_RET_L
1 2
9 10
NC
SPK (pull high)
SPKJ
Empty
NC
SPK
Audio Connectors: CD_IN1, AUX_IN1 (optional)