Foxconn 761GXK8MC-RS - Manual (Page 24)

17
Chapter 2 Installation Instructions
1394 Connectors: F_1394_1,F_1394_2
(Optional)
The 1394 expansion cable can be connected
to either the front (provided that the front panel
of your chassis is equipped with the appropri-
ate interface) or real panel of the chassis.
F_1394 _1/2
GND
12V
TPB -
GND
TPA -
1
12V
TPB +
GND
Empty
TPA +
Serial ATA Connectors: Serial ATA -1,
Serial ATA
-2
The Serial ATA header is used to connect the
Serial ATA device to the motherboard.
These connectors support the thin Serial ATA
cables for primary internal storage devices.
The current Serial ATA interface allows up to
150MB/s data transfer rate.
SATA_1/SATA_2
GND
GND
GND
TX+
TX-
RX+
RX-
1
S/PDIF Out Connector: SPDIF_OUT
The S/PDIF out connector is capable of pro-
viding digital audio to external speakers or
compressed AC3 data to an external Dolby
digital decoder.
SPDIF_OUT
5V
GND
Empty
DATA
1
Audio Interface: F_AUDIO
The audio interface provides two kinds of
audio output choices: the Front Audio, the
Rear Audio. Their priority is sequenced from
high to low (Front Audio to Rear Audio). If head-
phones are plugged into the front panel of
the chassis (using the Front Audio), then the
Line-out (Rear Audio) on the rear panel will
not work. If you do not want to use the Front
Audio, pin 5 and 6, pin 9 and 10 must be
short, and then the signal will be sent to the
rear audio port.
F_AUDIO
MIC_GND MIC
+5VAC MIC_PW R
AUT_RET_R AUD_OUT_R
EMPTY
AUD_OUT_L AUT_RET_L
1 2
9 10
NC
Note: The empty pin of SPDIF cable should be
aligned to empty pin of SPDIF out connector
PDF created with pdfFactory Pro trial version www.pdffactory.com