Foxconn 760GXK8MC RAID - Manual (Page 39)

Serial ATA RAID User’s Guide
Next, you can click “Yes” button to start the operation or click “No” button
to cancel. When you click “Yes” button to start this operation, the following
warning message will be popup.
Next, you can click “Ok” button to restart the windows and start the
operation “Source is a boot device” of . Or
click “Cancel” button to suspend this operation. But, this operation is still
done after restarting the windows next time.
c) To create a RAID 1 (Mirror) array, follow these steps:
NOTE: You should use two SATA hard disks to create a RAID1 array.
1. “Configuration” → “Create Raid” → “Raid Type” → RAID 1.
2. From the drop-down box “Mode Type”, select the mode type you want
or use the default value “DMA”.
3. From the “Available Disks” pane, select the disk and click downward
arrow icon or double click it to add the disk on the “Selected Disks”
pane. This action is the same as the operation to create a JBOD array.
4. When the RAID1 array’s configuration is finished, click the button
“Create”. Then a “Create Mirror RaidSet” dialog will be popup.
36