Formax FD 382 / FD 38X - Manual (Page 22)

MULTI-SHEET FEEDING
The multi-sheet feeder is designed to fold pre-collated stapled or unstapled sets of up to four 20 # (75gsm)
sheets of paper.
1. Adjust the side guides on the multi-sheet feeder for
the proper paper size. Loosen the brass thumb screw,
adjust the guides to fit the paper width and re-tighten
the thumbscrew (Fig 11a).
2. Slide the pre-collated paper set into the multi-sheet
feeder. When feeding stapled sets the documents
should be placed with the staple on the operator’s
side and leading (Fig 11b).
3. The sheets of paper will be automatically pulled into
the folder (there is a one-second delay after the paper
is placed in the feeder).
4. If the fold is skewed, turn the skew adjustment knob
located on the back of the feeder left or right to make
corrections (Fig 11c).
5. To remove the multi-sheet feeder depress the release
levers located on either side of the lower back side of
the feeder (Fig. 11d), tilt the feeder forward and lift.
To reinstall depress the levers and reinsert.
Staple
Fig. 12
Fig. 11a
Fig 11b
Brass thumbscrew
Skew Adjuster
Release Levers
Fig. 11c
18