Formax FD 382 / FD 38X - Manual (Page 20)

Stacker Override - FD 38X only
The FD 38X automated stacker positions may need to be
overridden to accommodate different types of paper in order
to improve the outfeed stacking (see pg 19 for FD 382 manual
stacker wheel adjustments). The positions are preset at the fac-
tory and should only be changed if needed. From the Operator
Settings screen select “Stacker Override”, and press the “ ” to
select.
1. “Stacker Override Positions are preset by fold settings
only change if needed” will be displayed. Press the
“ ” to enter the stacker override setup or the “C” button
to exit.
2. Using the “ ” buttons, select the standard fold that
the stacker position needs to be adjusted for. Press the
“ ” button to enter the selection.
3. Select the paper size using the “ ” buttons. Press
the “ ” button to advance.
4. Adjust the stacker wheel position up or down using the
“ ” buttons. The number shown “P1” is the factory
setting for the fold type and paper size selected.
5. Press the “ ” to save. To adjust stacker settings for ad-
ditional folds, repeat steps 1 through 4.
16