Fluke Biomedical SPOT Light - Manual (Page 21)

SpO2 Functional Tester
How to Set Custom Tests
9
As one example, to change the SpO2 value to 98 %:
1. Push  or  to move the highlight to
SpO2: in the display.
2. Push  . The highlight moves to the SpO2
parameter value as shown in Figure 5.
gvh005.jpg
Figure 5. SpO2 Parameter Change
3. Push  or  to scroll through the SpO2
parameter values until 98% shows in the display.
Note
As each parameter is set, the artificial finger
outputs the new parameter value immediately.
4. Push  . The highlight moves back to SpO2:
and the value stays set at 98 %.
How to Set Custom Tests
When the Test parameter is set to Manual, no parameter
values are stored. A maximum of three custom tests can
be stored in the Product.
To set up a custom test:
1. Push  or  to move the highlight to Test:
in the display.
2. Push  . The highlight moves to the Test
parameter.
3. Push  or  to scroll through the test
values. Stop when Custom 1, Custom 2, or Custom 3
shows in the display.
4. Push  .
When the Test parameter is set to Custom 1, Custom 2,
or Custom 3, each parameter you change becomes a
new value for that custom test.