Fluke Biomedical 07-494 - Manual (Page 11)

2
Getting Started
Indicators and Controls
2-3
Figure 2-2. Front Panel
Rear Panel
Refer to Figure 2-3 for rear panel layout.
Battery Access Cover: The battery access cover is located on the rear panel. Refer to Section 5,
Maintenance for battery replacement procedures.
NOTE
Be sure the unit is turned OFF before removing the
batteries.
BNC Connector: A BNC connector, located on the rear panel, provides a signal from the radiation
detection diodes. The signal can be observed on an oscilloscope during an exposure. However, the
signal lasts only as long as the exposure. Therefore, a storage scope or camera is required to view the
signal for extended periods of time.
CAUTION: Turn off power switch
before replacing battery. Use
MN16404 or equivalent alkaline
b tt
136058
Scope
Figure 2-3. Rear Panel