Flowserve Logix 520MD+ DD - Manual (Page 13)

DD User Manual - Logix® 520MD+ Series Digital Positioner FCD-LGENSF0013-01
© Flowserve Corporation
13
7 CONFIGURATION
View and set the configuration of the system.
7.1 Reset Factory Defaults
Reset all values back to the default state. This will affect the
positioner behavior and configuration settings will be reset.
After a factory reset, the positioner will need to be configured
and stroke calibration will need to be performed.

DANGER: Using this feature will result in valve movement
and the inability to operate the valve until the positioner is
calibrated. Notify proper personnel that the valve may
stroke, and make sure the valve is properly isolated before
proceeding.
7.2 Device Information
View the information about the system .
7.2.1 Revisions and Serial Numbers
View information about the system revisions and serial
numbers.
7.2.1.1 Software Release
View the software version number.
7.2.1.2 Electronic Serial Number
View the serial number assigned to the positioner. This
number is listed on the positioner label.
7.2.1.3 Valve Serial Number
View the valve serial number. This number is entered by the
user. See Valve Information.
7.2.2 Positioner Information
View information about HART and the positioner.
7.2.2.1 HART Manufacturer ID
View the positioner manufacturer.
7.2.2.2 HART Device Type
View HART device type of the positioner.
7.2.2.3 Diagnostics Level
View the diagnostic level of the positioner. Three levels are
possible - Standard, Advanced, and Pro.
7.2.2.4 Model Number
View the positioner model number.
7.2.3 Actuator Information
View and set information about the actuators.
7.2.3.1 Select Actuator Settings
Select actuators from a list to automatically look up and store
some of the actuator information.
7.2.3.2 Actuator Manufacturer
Select the actuator manufacturer from a list.
7.2.3.3 Actuator Model
Select the actuator model from a list.
7.2.3.4 Actuator Size
Select the actuator size. Selecting the area of the actuator is
important for some of the diagnostics that deal with force,
such as the friction values.
7.2.3.5 Actuator Spring
Select the actuator spring type from a list.
7.2.3.6 Actuator Style
Select the actuator style from a list.
7.2.4 Valve Trim Information
View and set information about the valve trim.
7.2.4.1 Trim Number/Size
Set the Trim Number/Size.
7.2.4.2 Trim Characteristic
Set the Trim Characteristic.
7.2.4.3 Trim Type
Set the Trim Type.
7.2.4.4 Trim Material
Set the Trim Material.
7.2.4.5 Stroke Length
Set the Stroke Length.
7.2.4.6 Stem Diameter
Set the Stem Diameter.
7.2.4.7 Packing Style
Set the Packing Style.
7.2.4.8 Bonnet Type
Set the Bonnet Type.
7.2.4.9 Pressure Balance
Set the Pressure Balance.
7.2.5 7.2.5.0 - Valve Body Information
View and set information about the valve body.
7.2.5.1 Valve Serial Number
Set the Valve Serial Number.
7.2.5.2 Valve Manufacturer
Set the Valve Manufacturer.
7.2.5.3 Valve Model
Set the Valve Model.
7.2.5.4 Valve Body Size