DirecTV HIRD-B1 - Manual (Page 16)

HUGHES-BRAND DIRECTV SYSTEM OWNER’S MANUAL
P AGE 2-4
Finishing Up
To achieve high quality sound from your digital satellite receiver through a stereo system, simply
connect the
AUDIO outputs (Left and Right) to an available input on your audio
system. This input may be labeled something like AUX, or, if you aren’t using a
compact disc player or laser disc player, you can use one of these inputs, if
available. The only input that you should not use is one that is specified for a
turntable/phonograph.
You can mix and match the different hookups described above to suit your
entertainment system’s available connections. For example, you could connect the VCR using
audio/video, while the TV is connected with the RF signal. Always try to achieve the highest quality
and greatest flexibility available.
Once all connections have been completed, plug in the TV, VCR and digital satellite receiver to the
wall outlet, appropriate extension cord, or surge protector. See Important Safety Instructions described
in the front of this manual.
Note: If you have connected a VCR into your entertainment system in a way that routes the cables
from your DIRECTV System to your VCR before the signal reaches the TV, you could experience a
distorted picture if you attempt to record a copy-protected program. These programs are identified
by a “Can’t Tape” symbol in the banner area of the screen. If this occurs, simply stop the recording
process and your picture will automatically correct itself.
Installing Batteries in Your
Remote Control
Before you can use your remote control, you must install the supplied AA batteries. First, unsnap the
battery cover from the back of the remote control. Install each fresh battery as shown, making sure that
the + and - on each battery line up with the marks in the battery compartment. Next, snap the cover
back onto the remote control.
Refer to “Programming Your Remote Control” for setting the codes to control the devices in your
entertainment system.
Now You Can Turn It On
Once you have connected everything, you can turn everything on. Turn the TV on and set it to the
digital satellite receiver channel (3 or 4) or input (video or S-video). Do the same for the VCR, if
applicable. Now turn your digital satellite receiver on. You will see the start-up screen for several
seconds, followed by a black screen with the message:
“Searching for satellite signal. To access related utilities, press .”
at the bottom of the screen. If so, this is good! If not, try pressing the key while the remote
control is in SAT mode or check all of the connections.
You’re well on your way to enjoying your DIRECTV System.
The phono-type audio cable and jack