Fire Magic Aurora Combined Stand-alone Post A430s - Manual (Page 21)

21
SHUTTING OFF THE UNIT
To shut off the unit, depress each valve control knob
and while pressing turn it clockwise to the OFF position.
Always close the valve from the gas supply after each
use of the unit.
ELECTRONIC LIGHTING
Note: Electronic lighting requires an installed 9-volt
battery with a good charge.
1. Open lid(s) or remove cover(s) from burner(s) to be lit.
2. Turn all gas control knob(s) to their OFF position(s).
3. Turn on the gas at its source.
Note: DO NOT
t u r n o n m o r e
than one valve at
a time for either
e l e c t r o n i c o r
manual lighting.
4. Depress the desired control knob for 5 seconds,
then, while pressing turn it counterclockwise to the
HI LIGHT position. Once the burner lights, release
the knob.
CAUTION: If a burner does not light within fi ve (5)
seconds of turning on the control knob,
depress the knob and turn it to the OFF
position. WAIT FIVE (5) MINUTES
before repeating step 4. If you smell
gas, follow the instructions on the cover
of this manual. If the burners still do not
light after several attempts, refer to the
instructions for manual lighting.
5. Repeat step 4 for each additional burner to be lit.
WHEN USING A PORTABLE PROPANE TANK
Propane tanks are equipped with a safety shutdown
device that may cause low or no gas pressure/fl ame
at the burners if operating and lighting instructions
are not followed exactly (See important note in the
TROUBLESHOOTING section for more details.)
MANUAL LIGHTING
CAUTION: Always wait fi ve (5) minutes for gas to
clear after any unsuccessful lighting
attempt.
1. Follow steps 1 through 3 (left).
2. Insert either a burning long-barrel butane lighter or
a burning long-stem match through the cooking grid
opening to the top of the lighting tube. (Fig. 21-2).
F o r b a c k b u r n e r s , h o l d t h e f l a m e
a g a i n s t t h e s u r fa c e o f t h e b a c k b u r n e r.
For sideburners, hold the fl ame against the burner.
3. Hold the match / lighter fl ame at the top of the lighting
tube for 5 seconds, or, next to the sideburner /
backburner. Then depress the appropriate control
knob and while pressing turn it counterclockwise to
the HI LIGHT position. Remove the lighter or match
when the burner lights, and release the control knob.
4. If the burner does not light, immediately depress
the knob and turn the valve to OFF. WAIT FIVE
(5) MINUTES before repeating steps 2 through 4
of the MANUAL LIGHTING instructions.
Read all instructions before lighting, and follow these instructions each time you light the unit.
Fig. 21-2 - Manual lighting
Lighter
Lighting
tube
Fig. 21-1 - Control knob
OFF
HI
LIGHT
LOW
T
O
TURN OFF
T
O
TURN
ON
Read setting
here
HIGH to
LIGHT
Read setting here
(OFF position shown)
To
Turn
OFF
To
T
urn
ON
Use
HI (high)
to light
Press
knob in
to turn
3. Hold the match / lighter fl ame at the top of the lighting
tube for 5 seconds, or, next to the backburner. Then
depress the appropriate control knob and while
pressing turn it counterclockwise to the HI LIGHT
position. Remove the lighter or match when the
burner lights, and release the control knob.
4. Set timer control knob to the desired cooking time.
5. Depress the desired control knob for 5 seconds,
then, while pressing turn it counterclockwise to the
HI LIGHT position. Once the burner lights, release
the knob.
6. Repeat step 5 for each additional burner to be lit.
SETTING THE TIMER
To use, set the dial (turn clockwise) to the desired time to
shut off. The dial is marked in 3 one hour increments (any
position in between is an estimate of that hour). The timer
dial will auto rotate (counter-clockwise) and will shut off
the gas supply when the dial reaches OFF (i.e. the time
is completed).
Important: When using the timer for periods of less than
one hour, you must fi rst set the dial to 1 hour
(to activate), then return (counter-clockwise)
to the desired amount of time. This will ensure
proper timer operation. See Fig. 21-4.
Read Here
Fig. 21-4
Timer knob in OFF position
4
Note: This unit must be connected to 120VAC power
for electronic lighting.
LIGHTING (IGNITION) INSTRUCTIONS