Fire Magic Aurora Combined Stand-alone Post A430s - Manual (Page 13)

13
PATIO MOUNT INSTALLATION (cont.)
SECURING THE PATIO MOUNT GRILL
Important: BEFORE USE, the patio mount base
must be securely fastened to a stable,
level surface to ensure the grill remains
fi xed and upright at all times.
Locate the patio mount base in the planned grill
location and mark the 4 holes. Drill the marked holes
to a
1 / 2 " diameter x 1 1 / 2 " depth. Insert the lag shields
(see PARTS LIST) into the holes, being sure that they
are fl ush with the ground.
Align the holes on the patio mount base over the lag
shields in the ground. Secure the base with the lag
screws (see PARTS LIST) using a
7 /
16
" nut driver.
CONNECT THE GAS SUPPLY
For household propane or natural gas units:
Route the fl ex connector to the gas stub.
Turn OFF the gas supply at the source. Remove the
adapter that is loosely connected to the fl ex connector.
Attach the adapter to the gas-supply stub using a pipe
compound resistant to all gasses. Tighten securely. Then
attach the open end of the fl ex connector to the adapter.
Tighten securely.
For propane cylinders:
For connecting a propane unit to a portable propane tank,
read the safety warnings and follow the instructions in the
section SAFE USE AND MAINTENANCE OF PROPANE
GAS CYLINDERS.
Important: An appropriate adapter will be required to
connect the existing fl ex connector to an
L.P. regulator/hose assembly.
LEAK TEST
Turn all burner control knobs to the OFF position. Turn the
gas supply on. Then carefully check all gas connections
for leaks with a brush and half-soap/half-water solution
before lighting. NEVER USE A MATCH OR OPEN
FLAME TO TEST FOR LEAKS.
RECONNECT POWER SUPPLY WIRES
CAUTION: IMPROPERLY CONNECTED WIRES WILL
CAUSE DAMAGE TO THE GRILL AND
MAY RESULT IN PROPERTY DAMAGE
AND/OR PERSONAL INJURY.
To connect the power supply box, connect the wires
coming from the power supply to the wire harness extension
as shown in Fig. 13-1.
Important: Apply dielectric grease to the male connectors
prior to making any wire connections.
RE-SECURE ACCESS PLATE
Carefully replace the access plate using the four screws,
ensuring all interior components are properly oriented
inside of the grill. Ensure the power supply cord (and fl ex
connector if applicable) coming out of the rear of the post
are properly situated and the plastic bushing/grommet
pieces are secure in place.
CONNECT POWER CORD
Plug the power supply cord into a properly wired,
grounded, and inspected GFCI electrical receptacle.
Use a heavy-duty grounded extension cord if necessary.
Note: Keep electrical supply cords away from all
heated surfaces.
REV 0 - 1412011435 L-C2-436
Fig. 13-1 Connect: Gas, Wires, Plate, Power
Wire
Connections
WARNING
Electrical Grounding Instructions:
This outdoor-cooking gas appliance is equipped
with a three-pronged (grounding) plug. Do not cut or
remove the grounding prong from the plug.
To GFCI
receptacle
Adapter Flex
connector
To gas supply
(as applicable,
fl ex location
may vary)