Fire Magic Echelon Diamond Built-In Grill - Manual (Page 35)

35
CONVERTING THE GAS TYPE
3. Unfasten the two back burner nuts (found on the left
side of the back burner) using a 1 /
4
" nut driver and
set them aside. See Fig. 35-2.
4. Remove the back burner by lifting the left side
outward and to the left. See Fig. 35-3.
5. Use a 3 /
8
" hex nut driver to remove the exposed orifi ce
and replace it with the correct orifi ce for the gas being
converted to (See Table 1 for size). Reference Fig.
35-4 for orifi ce orientation.
6. Replace the back burner assembly and fasten the
two nuts using a 1 /
4
" nut driver.
7. Replace the back burner cover and warming rack.
Fig. 35-1
Fig. 35-3
Fig. 35-4
Fig. 35-2
Orifi ce
CHANGING AN INFRARED BURNER ORIFICE
(IF EQUIPPED)
1. Remove the cooking grid from above the burner on
which you are working by lifting it fi rst from the front
and set it aside.
2. Unscrew both lighting tube hex head screws with a
3 /
8
" hex nut driver.
3. Remove the infrared burner by lifting the back of the
burner up so that both tabs are freed from their slots,
then lift the burner toward the back of the fi re box
and upward. Set the burner aside.
4. Use a 3 /
8
" hex nut driver to remove the exposed orifi ce
and replace it with the proper orifi ce for the new gas
(see Table 1 for sizing).
5. Replace the infrared burner by fi rst sliding it over the
orifi ce, then lowering the two tabs under the back of
the burner into the slots in the back burner rest.
6. Reattach the lighting tube and replace the grid so
that the cut-out section is in front.