Fire Magic Echelon Diamond Built-In Grill - Manual (Page 33)

33
POWER SUPPLY FUSE REPLACEMENT
1. Locate the power supply box inside of the island
enclosure (reference the PARTS LIST).
2. Using a phillips screwdriver, remove the 4 large
screws found on the cover of the power supply
box (see Fig. 33-1).
3. Disconnect the power supply cord. Then
disconnect the wire harness and ground wire
(see Fig. 33-2). Completely remove the box from
the enclosure for ease of fuse replacement.
4. Remove the 4 small screws found on the cover
of the power supply box (see Fig. 33-3).
Note: The 2 center screws do not need to be
removed.
5. Carefully open the box by pulling its cover away.
You may need to feed the wire harness into the
box to provide enough slack to open on the
other end. Then “push in and twist” the fuse
holder (red wire), exposing the fuse. See Fig.
33-4.
6. Replace the fuse accordingly (3AG 2 AMP).
Disconnect wire harness and ground wire (and power cord)
Fig. 33-2
Disconnect
here
Remove 4 large screws
Fig. 33-1
Carefully open box and replace fuse (red wire)
Fig. 33-4
Remove 4 small screws
Fig. 33-3